Filter
Top Products
Operating Instructions
11
Setting the water softener
Using the table as a guide, adjust the water softener to that which cor-
responds to the hardness of the water in your area:
0 The dishwasher must be switched off.
Setting manually:
1. Open the dishwasher door.
2. Remove the lower basket from the
dishwasher.
3. Turn the hardness range switch to 0
or 1 (see table).
4. Replace the lower basket.
Setting electronically:
5. Press the ON/OFF button.
The LED indicators for all the buttons in the control panel that are now
able to be selected will become illuminated.
3
If the only LED indicator illuminated is one that belongs to a pro-
gramme button, this means that this programme has been activated.
The programme must be cancelled (RESET):
Press function buttons 2 and 3 simultaneously for approx. 1 second.
The LED indicators for all the buttons in the control panel that are now
able to be selected will become illuminated.
6. Press function buttons 2 and 3 simultaneously and keep them pressed.
The LED indicators in function buttons 1 to 3 will flash.
7. Press function button 1.
The LED indicator for function button 1 will flash.
The multi-display will indicate the hardness setting.
The number of the acoustic signals heard (only when the acoustic sig-
nal has been activated) also corresponds to the hardness setting.
8. Pressing function button 1 increases the hardness setting by 1.
(Exception: hardness setting 1 follows hardness setting 10).
1) The water hardness will only be indicated acoustically if the acoustic signal has
been activated.
2) (°d) German degree, measure of the hardness of water
3) [mmol/l] millimol per litre, international unit for the hardness of water
4) On this setting the length of the programme may be slightly longer.
*) Factory setting