Filter
Top Products
Operating Instructions
29
Starting a programme
0 1. Check that the dishes and cutlery are loaded in the dishwasher in such
a way that the spray arms are free to rotate.
2. Turn on the tap fully.
3. Press the ON/OFF button.
The LED indicators for all the buttons in the control panel that are now
able to be selected will become illuminated.
4. Press the relevant button for the programme required (see “Programme
Table”).
The programme display will become illuminated.
The remaining time for the programme will be shown in the multi-dis-
play.
3
The remaining time for the programme is adjusted according to
amount of dishes, degree of soiling, etc.
5. Close the dishwasher door. The programme will begin.
3
If an error message is displayed in the multi-display and/or if an acous-
tic error message can be heard after the programme has begun, please
read the section “What to do if ...”.
Changing/interrupting/aborting a programme
3
Only change or interrupt a programme that is in progress if it is abso-
lutely necessary. After the appliance has been closed again, the air that
has entered will be heated significantly and expand. As a result, water
may collect in the base of the appliance and trigger the anti-flood sys-
tem.
Changing a programme
3
If you would like to change the programme before closing the dish-
washer door, briefly press the button for the new programme.
If you would like to change the programme after it has commenced,
proceed as follows:
1
Hot steam may escape when the dishwasher door is opened. There is a
risk of scalding! Be careful when opening the door of the dishwasher.
0 1. Open the door of the dishwasher. The programme will stop.
2. Press the button for the new programme and hold it down.
First, the indicator for the programme that is currently running will
flash.