Filter
Top Products
26
Care & Cleaning
If you are planning to use the oven directly after a self-clean cycle remember to allow time
for the oven to cool down and the oven door to unlock. This normally takes about one
hour. So to self-clean for 3 hours will actually take about 4 hours to complete.
STARTING THE OVEN SELF-CLEAN CYCLE
!
WARNING WARNING
WARNING WARNING
WARNING
During the self-cleaning cycle, the outside of the range can become very hot to the touch. DO NOT
leave small children unattended near the appliance; they may be burned if they touch the hot oven
door surfaces.
!
CA CA
CA CA
CA
UTIONUTION
UTIONUTION
UTION
DO NOT force the oven door open. This can damage the automatic door locking system. Use care
when opening the oven door after the self-cleaning cycle. Stand to the side of the oven when
opening the door to allow hot air or steam to escape. The oven may still be VERY HOT.
To start a Self-Cleaning cycle:
1. Be sure oven is empty and the oven door is closed.
2. Turn the selector knob to Clean position.
3. The corresponding indicator light will flash.
4. Turn the Temperature Control Knob to Clean position.
5. The Lock indicator light will flash while transitioning from unlock to lock. It will stop
flashing when the door is locked.
NONO
NONO
NO
TETE
TETE
TE
If the “Racks” indicator light is flashing when the clean mode is initiated, the oven racks and rack
glides with supports have not been removed. It will continue flashing, once the selector knob is set
back to the off position and the racks and rack glides with supports are removed from the oven.
6. As soon as the controls are set to clean, the motor driven oven door lock will begin to
close automatically. Once the door has been locked the indicator light will stop
flashing and remain on. Allow about 30 seconds for the oven door lock to close.