CLEANING THE OUTER AND INNER
DOOR GLASS PANELS
The outer oven door glass panels are removable
for cleaning.
TO REMOVE THE OUTER
1.Open the oven door slightly to gain access to
the two cross head screws on the top of the
oven door.
2.Loosen the two screws using a Pozidrive
screwdriver.
3.Holding the door glass securely in place with
one hand remove the screws and washers with
the other hand.
The screws and washers retain the trim on the
top of the grill door. Note the position of the trim
on the door.
4.Holding the door and glass with one hand,
gently pull towards you and slightly lift the door
glass with the other hand to disengage the
panel from the location point at the bottom of
the door. Gently release the door to close it.
5.Clean the outer and inner glass using hot soapy
water or Hob Brite. Should the inner face of the
outer door glass be heavily soiled it is
recommended that soapy water with a high
concentration of soap is used. To prevent
streaking a glass cleaning spray may be applied
and the glass polished with a soft cloth. Ensure
that all parts are well rinsed and thoroughly dry
before attempting to replace the outer door
glass.
27
If the door glass panel becomes
chipped or has deep scratches the
glass will be weakened and must be
replaced to prevent the possibility of
the panel shattering. Please contact
your local Service Force Centre who
will be pleased to advise further.
GLASS
To prevent damaging or weakening the
door glass panels avoid the use of the
following:
Household detergents and bleaches
Impregnated pads unsuitable for
non-stick saucepans
Brillo/Ajax pads or steel wool pads
Chemical oven pads or aerosols
Rust removers
Bath/Sink stain removers.
Grill Door Trim