Filter
Top Products
TO REPLACE THE OUTER DOOR
GLASS
1.Holding the door glass panel with both hands,
gently place the locators into the holes of the
brackets at the bottom of the oven door.
2.Holding the door glass with your left hand, use
your right hand to open the oven door.
Bring the door gently towards the glass panel
ensuring the screw location holes line up.
3.Place the trim in the correct position on the top
of the grill door.
4.Hold the glass in place with one hand and insert
the cross head screws with washers into the
location holes with the other hand. Give the
screws one turn to ensure the glass is secure.
5.Tighten the screws positively with a Pozidrive
screwdriver before closing the oven door.
TO CLEAN THE INNER GLASS DOOR
The inner glass door is not removable. Clean
using hot soapy water or Hob Brite and a soft
cloth. DO NOT use abrasives as they may
damage the glass or seal.
CLEANING INSIDE THE OVENS
The oven top, sides and back panels are coated
with a Stayclean finish.
The Stayclean areas should not be cleaned
manually. See Care of Stayclean Surfaces on
page 29.
The base of the ovens can be cleaned using
normal oven cleaners or aerosol oven cleaners
with care. Ensure that the manufacturers
instructions are followed and that all parts are well
rinsed afterwards.
Do not use any cleaning agents or scrapers on
the oven tops, sides, back panels and door seals.
Damage will occur if soap impregnated steel
wool pads, aerosol cleaners or any abrasive
cleaners are used.
28
DO NOT attempt to use the oven
without the glass being in place.
Grill Door Trim