Filter
Top Products
TO REPLACE THE OUTER
DOOR GLASS
1.Holding the door glass panel with both hands,
gently place the locators into the holes of the
brackets at the bottom of the oven door.
2.Holding the door glass with your left hand,
use your right hand to open the oven door.
Bring the door gently towards the glass panel
ensuring the screw location holes line up.
3.Place the trim in the correct position on the
top of the grill door.
4.Hold the glass in place with one hand and
insert the cross head screws with washers
into the location holes with the other hand.
Give the screws one turn to ensure the glass
is secure.
5.Tighten the screws positively with a Pozidrive
screwdriver before closing the oven door.
TO CLEAN THE INNER GLASS
DOOR
The inner glass door is not removable. Clean
using hot soapy water or Hob Brite and a soft
cloth. DO NOT use abrasives as they may
damage the glass or seal.
CLEANING INSIDE THE OVENS
The oven top and sides are coated with a
Stayclean finish. The back panels are vitreous
enamelled.
The Stayclean areas in the ovens should not be
cleaned manually. See Care of Stayclean
Surfaces on page 30.
The main oven base and back panels can be
cleaned using normal oven cleaners or aerosol
oven cleaners with care. Ensure that the
manufacturers instructions are followed and
protect the oven burner with foil to prevent it
from becoming blocked. Do not spray aerosol
cleaners through the aperture in the back panel
as the cavity behind is coated with a Stayclean
finish.
Take care when cleaning round the back panel
aperture.
Do not use any cleaning agents or scrapers on
the oven roof, sides and door seal.
Damage will occur if soap impregnated steel
wool pads, aerosol cleaners or any abrasive
cleaners are used on the Stayclean finish.
29
DO NOT attempt to use the oven
without the glass being in place.