Electrolux EDB 876 Oven User Manual


 
THINGS YOU NEED TO KNOW
In the interest of safety this appliance must
be installed and / or serviced by a competent
person (Corgi registered). Safety may be
impaired if installation is not carried out in
accordance with these instructions.
This appliance must be earthed.
Do not remove the screws from the earth tab
extending from the oven mains terminal block
(Fig. 1).
Before connecting the appliance make sure
that the gas type and the voltage of your
electricity supply is the same as that indicated
on the rating plate. The rating plate can be
seen on the rear panel of the appliance.
Do not alter the electrical circuitry of this
appliance.
NOTE: HOUSE CIRCUIT
Earth leakage / continuity tests must be carried
out before the appliance is connected to the
mains supply and re-checked after fitting.
NOTE: It is good practice to:
Fit an Earth Leakage Circuit Breaker to your
house wiring.
Wire your appliance to the latest IEE
regulations.
THINGS TO NOTE
LOCATION OF APPLIANCE
The appliance may be located in a kitchen, a
kitchen/diner or bedsitting room, but not located
in a bathroom or shower room.
L.P.G. cookers MUST NOT be installed below
ground level i.e. in a basement or aboard any
boat, yacht or other vessel.
It is essential that there is a minimum
clearance of 2mm between the top surface
of the appliance and the inside top of the
cabinet.
This appliance is designed to be fitted
between cabinets with the recommended
dimensions as shown in Figs. 2 and 3.
38
INSTALLATION INSTRUCTIONS
WARNINGS:
Fig.1
Fig.2
Fig.3