Electrolux EMS26415 Microwave Oven User Manual


 
electrolux installation
34
The best position is above the cup-
board, see (A).
Connect the appliance to a single
phase 230-240 V/50 Hz alternating
current via a correctly installed earth
socket.
If the appliance is to be operated in a
non-European country, the supply
voltage, current type and frequency
of the appliance indicated on the
rating plate must correspond with the
specification of your power supply.
The rating plate can be found on the
inside face of the control panel.
The power supply cord may only
be replaced by an electrician.
Before installing, tie a piece of string
to the power supply cord to facilitate
connection to point (A) when the
appliance is being installed.
When inserting the appliance into
the high-sided cupboard, DO NOT
crush the power supply cord.
Do not immerse the power supply
cord or plug in water or any other
liquid.
Electrical connections
WARNING: THIS APPLIANCE
MUST BE EARTHED.
The manufacturer declines
any liability should this safety
measure not be observed.
If the plug that is fitted to your
appliance is not suitable for your
socket outlet, it must be cut off and
the appropriate plug fitted.
Remove the fuse from the cut off
plug. The cut off plug should then be
disposed of to prevent the hazard of
shocks in case it should be plugged
into a 13 Amp socket in another part
of your home.
IMPORTANT
The wires in the mains lead are coloured
in accordance with the following code:
GREEN AND YELLOW EARTH
BLUE NEUTRAL
BROWN LIVE
If you fit your own plug, the colours of
the wires in the mains lead of your
appliance may not correspond with the
markings identifying the terminals in your
plug, proceed as follows:
Connect the green and yellow (earth)
wire to the terminal in the plug which
is marked with the letter ”E” or the
earth symbol ( ) or coloured green
and yellow.
Connect the blue (neutral) wire to the
terminal in the plug which is marked
with the letter ”N” or coloured black.
Connect the brown (live) wire to the
terminal in the plug which is marked
with the letter ”L” or coloured red.
(A)
13 AMP
GREEN & YELLOW
13 AMP FUSE
BROWN
CORD CLAMP
BLUE