Filter
Top Products
36
Fitting under a counter
(kitchen worktop or sink)
By removing the machine’s worktop, you can install it under a close fitting sink unit
or a pre-existing top, providing the dimensions of
the recess correspond to those shown in the
picture.
Proceed as follows:
- Remove the machine’s worktop by unscrewing
the two front retaining screws, pull from the
front and slide out the rear slots, lifting the
worktop.
Insert the machine after adjusting height and
levelling with the adjustable feet. When inserting
the machine, ensure that the water inlet and drain hoses are not kinked or squashed.
Levelling
Good levelling is essential for correct closure and
sealing of the door.
When the appliance is correctly levelled, the door
will not catch on the levelling spacers on either
side of the cabinet.
If the door does not close correctly, loosen or
tighten the adjustable feet until the machine is
perfectly level.
820
570-600
450
IN04
Installation and connection instructions
IN06
IN07
152968 86/0en/UK 11-07-2003 14:44 Pagina 36