Filter
Top Products
Operating Instructions
34
3. Press the button for the additional 3in1 function.
The indicator for the 3 in 1 function becomes illuminated.
– The addition of special salt and rinse aid from each respective supply
container is prevented.
– The displays will no longer indicate a shortage of salt or rinse aid.
4. The function can be switched on or off by pressing the 3in1 button.
The 3in1 display will indicate the current setting:
5. Press the relevant button for the cycle required (see ”Cycle Table”).
The selected cycle will begin after approximately 3 seconds.
The function can no longer be changed after the cycle has begun. In
this case the dishwashing cycle must be aborted, and must then be
reselected.
3
If the additional function has been selected once, it will remain acti-
vated for all subsequent wash cycles unless it is deactivated by pressing
the button again.
3
The cycles lengths given in the cycle table may change if the additional
function is used.
3
When changing from 3-in-1 dishwashing tablets to conventional
detergent please be sure above all to take note of the last 3 points in
the chapter ”Using 3-in-1 dishwashing tablets”.
Setting or changing the start delay
Using the start delay timer you can adjust when within the next 19
hours the programme is to begin.
Setting the start delay:
0 1. Open the door of the dishwasher.
2. Press the ON/OFF button.
The LED indicators for all programme buttons (and the button for the
delay start timer if present) light up. The LED indicators and any option
buttons that are present only light up if they are activated.
3. Continue pressing the b button until the number of hours until the
programme is to start is flashing in the multi-display.
The 3in1 indicator is illuminated Function activated
The 3in1 indicator is not illumi-
nated
Function deactivated
(ex-factory setting).