Filter
Top Products
Operating Instructions
39
After remedying the O , ` or \ error, shut the door.
After rectifying an Å10 or Å20error, press the button for the dish-
washing cycle that has been started. The dishwashing cycle will con-
tinue.
If the fault is displayed again, please contact customer service.
3
For all other errors displayed, please contact customer service, stating
the error code. (See chapter “Customer Service”).
Two short continuously
repeated warning tones can
be heard; the cycle display
for the selected cycle is
flashing; error code
Å20is
displayed in the multi-dis-
play.
The siphon is blocked. Clean out siphon.
The water drain hose has
not been correctly laid.
Check hose installation.
Three short continuously
repeated warning tones can
be heard, error code
Å30is
displayed in the multi-dis-
play.
The leak prevention system
has been triggered.
Turn off the tap and
contact customer serv-
ice.
One long continuously
repeated warning tone can
be heard; the
O indica-
tor is continuously illumi-
nated.
The middle spray arm is
jammed.
Open the door care-
fully. Hot steam may
escape when the door is
opened. There is a risk of
scalding. Arrange the
dishes and cutlery in the
racks so that the spray
arm above can rotate
freely. Close the dish-
washer door.
The ` indicator is continu-
ously illuminated.
The door of the dishwasher
is open.
Close the dishwasher
door.
The \ indicator is contin-
uously illuminated:
The indicator \ is only
intended to remind you to
occasionally check the dish-
washer’s filter and to clean
it out when necessary. It
becomes illuminated at reg-
ular intervals, regardless of
the state of cleanliness of
the filter.
The indicator goes out
automatically at the
start of the next dish-
washing cycle.
Malfunction Possible cause Remedy