Filter
Top Products
31
Moving your appliance
You may damage some soft or badly
fitted floor coverings when you move
the appliance. The floor covering
under the appliance should be
securely fixed so it does not ruck up
when you move the appliance
across it. Alternatively you could
remove the floor covering. This
appliance is heavy and care must be
taken when moving it. Do not try to
move the appliance by pulling the
door handles.
To move the appliance, open the
grill door. Raise the appliance off its
front feet by lifting it from inside the
oven. Pull the appliance forward.
When you replace the appliance
push it back to the stop and make
sure there is the same gap at each
rear corner.
For your safety
Do not try to disconnect the
appliance from the gas supply if the
supply pipe does not have a bayonet
connection, as described in the
installation instructions. If this is the
case contact the person who
installed the appliance.
Location of appliance
This appliance must not be installed
in a bed-sitting room of volume less
than 20m
3
or in a bathroom, shower
room or garage. It is essential that
the appliance is positioned as Fig
1a. Shelves, wall cabinets and
cooker hoods must be fitted a
minimum of 787mm directly above
the top of the hotplate (or greater for
cooker hoods if recommended by
manufacturers instructions) and
400mm above the hotplate when
fitted in line with the outside of the
appliance.
Fig 1.a
Fig 1.b