Filter
Top Products
36
Electrical connection
A correctly installed, earthed socket is required for the electrical sup-
ply. The supply must have a fuse rating of at least 10 Amps. If the
socket is not accessible once the appliance is built in, the electrical
installation must include suitable means of isolating the appliance
from the mains (e.g. a fused spur).
Before initial start-up, refer to the appliance rating plate to ascertain
if supply voltage and current values correspond with those of the
mains at the installation location.
e.g.: AC 230 ... 240 V 50 Hz or
230 ... 240 V ~50 Hz
(i.e. 230 to 240 volts alternating current, 50 Hertz)
The rating plate is inside the appliance on the left.
☞
Installation
Your appliance needs air
For safety reasons, minimum venti-
lation must be as shown Fig.
Attention: keep ventilation ope-
nings clear of obstruction;
50 mm
min.
200 cm
2
200 cm
2
min.
D567
Housing dimensions
Height 1780mm
Depth 550 mm
Width 560 mm
Rehingeing the door
The appliance’s door has been locked in position for transport by means of
pins on both sides. According to the door opening direction, remove relevant
pins at the top and at the bottom.
Warning! When changing the side at which the door opens, the
appliance may not be connected to the mains. Remove plug from the
mains beforehand.