Filter
Top Products
40
Starting up and temperature regulation
☞
1. Insert the plug into the plug socket. When the refrigerator compart-
ment door is opened, the internal lighting is switched on.
2. Press ON/OFF button.
The green mains pilot indicator and the temperature display illuminate.
3. Press either the „+“ (WARMER) or „-“ (COLDER) button.
The temperature display switches over and the DESIRED temperature
currently set flashes on the temperature display.
4. Set the required temperature by pressing the „+“ (WARMER) or „-“
(COLDER) buttons (see section "Temperature setting buttons"). The
temperature display will immediately show the changed setting. With
each further press of one of the two buttons, the DESIRED tempera-
ture is adjusted by 1°C.
Adjustable temperature range: +3°C to +8°C.
Note: From a food safety point of view, +5°C for the refrigerator com-
partment and -18°C for the freezer compartment should be con-
sidered cold enough as a storage temperature.
5. Once the required temperature has been set, after a short period
(approx. 5 sec.) the temperature display will change and again indicate
the current ACTUAL temperature inside the fridge. The display will
change from flashing to continuous illumination.
The compressor will start and then run automatically.
Information! When the setting is changed, the compressor does not
start immediately if automatic defrosting is currently taking place.
In order for the appliance to run properly in certain conditions a slight
heating of the back surface of the inner container can take place.
Prior to Initial Start–Up
Please clean the appliance interior and all accessories prior to initial
start-up (see section: “Cleaning and Care”).
Standby time
The oil for automatic lubrication contained in the compressor may
flow into the refrigeration circuit if the appliance is transported in an
inclined position. To allow the oil to flow back into the compressor,
wait approximately 1 hour before placing the appliance in operation.
☞