Filter
Top Products
29
This item is detailed mode setting of home function. This item will vary with ‘SELECT
MODE’ item.
GO.
Go to execute home function (HOME FUNC ON only).
EXIT
Exit the HOME SETTING menu.
13. SEQUENCE
Sequence parameters can be set on this page.
SEQUENCE LINE
There are four sets of sequence lines built in dome camera. You can choose a line to
execute. Please use LEFT/ RIGHT of direction key to select your sequence line.
SEQUENCE POINT
There are 32 sets of sequence points can be specified in every sequence line. The
sequence points are linked list. Sequence function will go through the linked list
again and again.
PRESET POSITION
You can specify a preset position where the dome should go to at this sequence
point.
SPEED
Speed is adjustable from 1~15.
DWELL TIME
Dome will stay on the sequence point for “DWELL TIME” then go to next sequence
point.
RUN SEQUENCE
User can command dome camera to execute sequence function.
EXIT
Exit the SEQUENCE menu.
14. AUTOPAN
AutoPan parameters can be set on this page. User can enable dome camera to do
continuously panning without limit through setting the start point the same as endpoint.
START POINT
Start position of the “AUTOPAN path”.
TO FIND: Press ‘ENTER’ to go into joystick mode. User can move camera to
suitable position under joystick mode.
TO SAVE: Press ‘ENTER’ to set this position as start point and escape joystick
mode.
END POINT
End position of the “AUTOPAN path”.
TO FIND: Press ‘ENTER’ to go into joystick mode. User can move camera to
suitable position under joystick mode.