Filter
Top Products
8
1. Press a number key to set a sequence line such as <1>. Press <SET
SEQ.> to start modifying parameters of sequence 1.
2. LCD is displaying “001. PST SPD DWELL” now. You can edit the
parameters such as <4> <ENTER> for PST, <1> <5> <ENTER> for SPD
and <5> <ENTER> for DWELL. That means that the first preset point for
sequence 1 is preset point 4, dome camera will staying 5 seconds there and
dome will go to next preset with speed 15.
3. LCD is displaying “002.PST SPD DWELL” now. Please edit the parameters.
4. LCD is displaying “003.PST SPD DWELL” now. Please press <SETUP> to
end the session if you need two presets only.
■ Execute sequence function
1. Press a number key to specify a sequence number what you want to
execution.
2. Press <RUN SEQ.> to start sequence function.
■ Cruise Function Operation
■ Setting
1. Press <CRUISE> key on keyboard to select execution mode of cruise
function.
2. LCD is displaying “1. RUN 2.SETTING” now. Press <2> to enter
modification mode.
3. LCD is displaying “ENTER for START POS”. Press <ENTER> to start to
input cruise path.
4. LCD is displaying “ENTER for END POS”. You can move dome camera to
patrol a path. Press <ENTER>
5. LCD is displaying “ENTER for SAVING”. Press <ENTER> to command
dome camera recording this cruise path.
■ Execute cruise function
1. Press <CRUISE> key on keyboard to select execution mode of Cruise
function.
2. LCD is displaying “1. RUN 2.SETTING” now. Press <1> to start cruise
function.