Filter
Top Products
WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity before servicing. Check appliance is safe when you have finished.
23
9. To Remove the Grill Door
Remove the control panel (see 1). Remove the left-hand side
panel (see 2). Remove the centre cover strip (5 screws, 2 top, 2
bottom, 1 in middle). Remove the two countersunk screws (1
each side) securing the grill hinge arms to the front of the grill
chamber.
Note: The arms are spring tensioned. Carefully remove the grill
door. Retain the gaskets.
Reassemble in reverse order ensuring that the gasket is fitted
between the hinge arm and the front of the grill chamber.
10. To Remove Grill Element
Disconnect from electricity supply.
Remove grill pan from inside the grill compartment; remove
the enamelled front shield from the grill roof, by undoing the
two screws and washers.
Remove the two screws and washers securing the grill
element front support. Remove the screws from the grill
element.
Lift the element out carefully, disconnecting the leads from
the element terminals (noting their position). If it is not
possible to disconnect the leads in this way, pull the cooker
forward to gain access to the rear, remove the screws securing
the electric cover to the back sheet, remove the cover and
disconnect the terminals from the rear.
Fit the new element and reassemble in reverse order. Check
the operation of the grill.
11. To Replace an Oven Door
Open the oven door. Support the door and remove the two
screws securing the upper hinge and gasket to the cooker
front (Fig.7-2). Remove the door from the lower hinge by
lifting slightly and moving outwards (Fig.7-3).
The door is heavy, so take care.
Reassemble in reverse order.
12. To Adjust an Oven Door Angle
The bottom hinge of either oven door can be adjusted to alter
the angle of the door (Fig.7-4). Loosen the bottom hinge
fixing screws and use the notch and a flat bladed screwdriver
to move the position of the hinge to set the hinge position
(Fig.7-5).
Retighten the hinge screws.
13. To Replace an Oven Door Outer Panel
Move the cooker forward to gain access to the sides.
Open the oven door slightly and remove the front panel fixing
screws from the door sides – two each side (Fig.7-6).
Carefully lift off the outer door panel.
Remove the two plastic blanking plugs from the door handle.
Remove the door handle from the panel by unscrewing the
two retaining nuts. Fit the door handle to the new panel and
refit the two blanking plugs to the fixing holes.
Note: If replacing the outer panel on the right-hand door
(with the Thermodial), take care to make sure the sensor of
the Thermodial is sealed to the door by the rubber grommet
(Fig.7-7).
Fit the panel to the door. Reassemble in reverse order.
ArtNo.216-0009 - Elan
removing the handles
Fig.7-1
ArtNo.320-0001 Door hinges
�
ArtNo.320-0001 Door hinges
�
Fig.7-2 Fig.7-3
ArtNo.320-0007 Oven door hinge adjustment 2
Fig.7-5
ArtNo.320-0006 Oven door hinge adjustment 1
Fig.7-4
Effect of hinge adjustment - exagerrated for clarity
Centreline of hinge pin
Oven door omitted for clarity
ArtNo.320-0002c
- Oven door side screws (Elan)
Fig.7-6