Filter
Top Products
9
Lock
The Lock function disables all the other functions on the
DishDrawer. This function is useful when cleaning the
control panel and can also prevent children from turning
the DishDrawer on or off accidentally. This button can be
used when the DishDrawer is in operation and will remain
active until the Lock is deactivated.
To activate this function, press and hold the Lock button
until the key symbol at the bottom of the Electronic
Display appears continuously and is no longer blinking.
All the other buttons are now inactive.
To deactivate this function, press and hold the Lock button
until the key symbol in the Electronic Display
disappears.
Figure 2 - Electronic
Display showing the lock
mode
Start / Pause
This button has a number of functions. It serves to:
· Start the DishDrawer, once the desired wash program has been selected.
· Interrupt the wash program while in operation.
When pausing the DishDrawer, wait until you have heard two additional
beeps before you open the drawer, allowing the lid seal to deflate.
While in the pause mode, the electronic display will be green, the min
symbol will flash and the "smiley face" symbol will disappear.
· Restart the DishDrawer after being paused.
You may notice a delay after the Start / Pause has been pressed. During this
time the lid seal will be inflating.
· One Button Start.
This starts the DishDrawer and will run the last wash program used,
excluding Delay Start if used in the previous wash.
· Initiates the Delay Start.
NOTE:
Under no circumstances do we recommend that you open the DishDrawer while in
operation unless you have pressed the Start / Pause button. If the drawer is opened
during the wash program, there is a possibility of getting wet, burnt, or damaging the
DishDrawer. There are safety mechanisms in place to stop the DishDrawer if it is
opened.
If Fault Code U2 Appears:
The fault code U2 will be displayed if the drawer is opened during operation. To
remove this fault code, press Power. Ensure the drawer is closed. The DishDrawer
will now be ready to start from the beginning of the wash program. You may have to
add more detergent in the dispenser and then press the Start / Pause button to start the
DishDrawer. The DishDrawer will not restart where it was interrupted after a U2 fault.