Filter
Top Products
22
Auto Power
When the Auto Power feature is on it turns the DishDrawer automatically to the
Normal Operating Mode whenever the drawer is opened. Auto Power lights up the
Electronic Display and a series of beeps are emitted when the DishDrawer is opened.
When the DishDrawer leaves the factory, Auto Power is programmed to occur,
however this can be turned on or off as desired.
Enter into the Option Adjustment Mode as explained previously.
Pressing the Lock button will turn the Auto Power on or off.
When the smiley face symbol is displayed the Auto Power is on and if the
smiley face symbol is not present then the Auto Power feature is off.
Press the Power button to return to the Normal Operating Mode.
When Auto Power is turned off, the Electronic Display does not light up when the
drawer is opened and there are no beeps. To turn the DishDrawer on, press the
Power button or the Start / Pause button to start the dishwasher.
Note: If the mains power supply is turned off then the Auto Power feature will
default to the factory setting.
Water Pressure
The DishDrawer is programmed at the factory to suit most water supply pressures.
However, if the DishDrawer is used in very low water pressure situations (£4psi), it
may result in a U1 fault code. Should this happen then the water pressure setting
should be changed.
Enter into the Option Adjustment Mode as explained above.
Pressing the Start / Pause button will change the water pressure settings.
The electronic display will show which water pressure the DishDrawer is set to. If
HP is showing on the electronic display this indicates high or standard pressure
or LP meaning low pressure.
Press the Power button to return to the Normal Operating Mode.
Warning:
Under no circumstances do we recommend you change your water pressure setting to
LP if you have high or standard water pressure. Failure to follow this can result in
damage to your DishDrawer or property.