Filter
Top Products
21
OPTION ADJUSTMENT MODE
After using the DishDrawer, you may want to change some of the preset options to suit
your needs. The following settings can be changed:
Rinse Agent
Auto Power
Water Pressure
To make these changes it is necessary to enter into the Option Adjustment Mode.
To Enter Option Adjustment Mode
Press Power to turn the DishDrawer on. The electronic display will be green.
Press and hold the Program and Eco Save buttons simultaneously for five
seconds.
When the buttons have been pressed correctly the DishDrawer will emit one long
beep.
Release the two buttons. The electronic display will be red and the secondary
control panel light(s) will be orange. See below for further details.
Use the buttons on the primary and secondary control panel to make your
changes to the pre set options. These are explained below.
Once you have made these changes, press the Power button to return to the
Normal mode. The DishDrawer will save these changes automatically.
To make further changes repeat the above steps from the beginning.
Rinse Agent Setting
Enter the Option Adjustment Mode as explained above.
The current rinse agent setting is shown on the secondary control panel in orange
lights.
Press the Program button to advance the setting. For example two orange lights
indicate the rinse agent setting is set at two. The options are from one to five.
Once you have selected the rinse agent setting you require, press the Power
button to return to the Normal mode.