Filter
Top Products
599464
13
3.8
Temperature & Voltage Display Mode
(Not available on integrated or flat door models)
During a wash cycle, the current water temperature or the power supply rail
voltage of the controller can be displayed on the LCD instead of the time
remaining. To enter temperature/voltage display mode, start a wash cycle as
normal. Initiate a keylock by pressing and holding the KEYLOCK button for 4
seconds.
Once in keylock mode, press and hold START/PAUSE for 8 seconds to enter
temperature display mode. The display now alternates between a °C symbol
and the water temperature. Pressing the START/PAUSE again changes the
display to alternate between an °E symbol and the power supply rail voltage
of the controller.
To cancel temperature/voltage display mode, press the POWER button.
3.9
Show Off/Showroom Wash Mode
This mode initiates a shop show off display and wash operation
demonstration.
With the DishDrawer™ powered up and turned on, the show off mode is
entered by pressing and holding the ECO and POWER buttons
simultaneously for 5 seconds. Ensure that ECO is pressed first.
The DishDrawer™ is now in the show off mode and cycles through all of the
LED & LCD segments.
Pressing the POWER button now puts the DishDrawer™ into the showroom
wash mode. Before running this, mode the tub should be filled with water
until it is just touching the underside of the spray arm. The showroom wash is
started by pressing the START/PAUSE button whereby the following cycle is
run:-
The lid is pulled down.
The wash motor starts and runs for 4 minutes.
The wash motor stops.
The lid is lifted.
The display counts down to zero throughout this cycle.
The DishDrawer™ turns off at the end of this cycle.