Filter
Top Products
599464
6
Press KEYLOCK to advance the rinse aid setting. Once the desired setting is
achieved, press POWER to exit. The rinse aid index is stored in EE memory,
so even with the power removed, the rinse aid level is retained.
2.1.2 Water Supply Hardness Setup (hd) (Where Fitted)
The current supply hardness setting is shown using the red LED’s on the
touch switch panel. One of 5 settings should be selected according to the
known hardness of the supply water. Each setting is appropriate for the
following water supply hardness:
No LED Water Softener turned off, continuous bypass of softener.
1 LED 150-250 ppm water supply hardness.
2 LEDs 250-350 ppm water supply hardness.
3 LEDs 350-450 ppm water supply hardness.
4 LEDs 450-550 ppm water supply hardness.
5 LEDs 550-625 ppm water supply hardness.
Press KEYLOCK to advance the Water Softener setting. Once the desired
setting has been achieved, press POWER to exit.
Selection of a setting affects how the Electronic Controller diverts supply
water, how much water is treated, and how much salt is used in regeneration,
in a manner that optimises the performance of the Water Softener.
2.1.3 Auto Power Option (AP)
The automatic power up sequence that occurs when the tub is opened can be
turned on or off using the KEYLOCK button. If the scrubbing brush symbol is
showing on the LCD, then the auto power up sequence will occur when the
tub is opened. If the scrubbing brush symbol is not showing, then the
DishDrawer™ will not automatically power up when the tub is opened (the
customer will need to press the power button each time they wish to use the
DishDrawer™). Press POWER to exit when the desired setting has been
selected.
2.1.4 End of Cycle Beeps (EC)
The six beeps that occur at the end of the cycle can be turned on or off using
the KEYLOCK button. If the scrubbing brush symbol is showing on the LCD,
then the end of cycle beeps are activated. If the scrubbing brush symbol is
not showing, then the end of cycle beeps are deactivated. Press POWER to
exit when the desired setting has been selected.