Filter
Top Products
599464
5
2 OPTION ADJUSTMENT
2.1 Changing Setup Options
To enter the option adjustment mode, press POWER to turn the LCD on, then
hold the ECO button and KEYLOCK button simultaneously for 5 seconds,
ensuring that ECO is pressed first. Once the option adjustment mode is
entered, a beep is emitted and the LCD displays the letters rA. Pressing the
START/PAUSE button scrolls through the options and allows changes as
follows:-
Rinse Aid Setup (rA).
Water Supply Hardness Setup (hd). (Water softener models only)
Auto Power Option (AP).
End of Cycle Beeps (EC).
Closed Drawer Option (Ld).
Clean/Dirty Dish Symbol (dS).
Integrated and flat door models:- On an integrated or flat door
DishDrawer™ where there is no display, the option chosen is indicated by the
lights showing on the integrated badge as follows:-
Rinse Aid Setup (red light above START/PAUSE button).
Water Supply Hardness (green light above START/PAUSE button).
Auto Power Option (orange light above START/PAUSE button).
End of Cycle Beeps (green light above START/PAUSE button and ECO light
is red).
Closed Drawer Option (red light above START/PAUSE and ECO light is red).
Clean/Dirty Dish Symbol (not available on Integrated or flat door models).
Dry Enhancement Option (no light above buttons, ECO light is red).
Press POWER at any time to exit this setup mode.
2.1.1 Rinse Aid Setup (rA)
The current rinse aid setting is shown using the red LED’s on the touch switch
panel.
The amount of rinse aid dispensed into a rinse cycle can be varied to suit the
level of hardness of the local water supply. It is adjusted for 1 - 5 dispensing
levels.
(1 = approx 0.5mls (1/10) teaspoon of rinse aid, 5 = approx. 2.5mls (1½)
teaspoon of rinse aid).