Filter
Top Products
I
N
T
E
G
R
A
T
E
D
P
R
O
D
U
C
T
O
N
L
Y
Use a small amount of
liquid soap along the lip
of the seal to assist the
Drawer Front to slide on
easily against the seal.
The Electronics Board is
an electrostatic sensitive
device. Ensure you are
adequately grounded
when connecting or
disconnecting the badge
by wearing a grounding
strap or by grounding
yourself to the
DishDrawer.
WARNING
TIP
WARNING
Ensure the product is not
plugged in.
STEP 6.5 FITTING THE DRAWER FRONT PANELS TO THE
DISHDRAWER
6.5.1
Fit seal to Drawer.
6.5.2
Plug the badge grounding wire onto the
Drawer Front Panel.
Connect badge wires to the integrated
badge port on the Electronics Board.
6.5.3
Fit the Drawer Front by sliding in an inwards
and upwards motion. The rubber seal
between the Drawer and Drawer Front must
be kept in place.
6.5.4
Ensure the slide hooks (on slide) are as far
forward as possible, (as shown). Insert pins
to lock in place, ensuring that the rib on the
pin is vertical.
6.5.5
Check fit and air flow gap and adjust if
necessary.
CORRECT
ü
û
INCORRECT
View of Slide Hooks
Page DD_21