Filter
Top Products
2.1.5
Position the Foot Slide Retainer within the
cutout areas of the Template.
2.1.6
The Template should be placed in the cavity
until the wings just touch the existing
cabinetry. This ensures the front of the
DishDrawer will be flush with the existing
cabinetry.
IMPORTANT
For Integrated product
with door thickness other
than
3
/
4
(18mm), the
Foot Slide position must
be adjusted forward or
back to allow for this
difference.
2.2.1
The first and preferred option is to screw the
Retainer to the floor. The tabs can be broken
off at the perforations, if they are not used.
2.2.2
The second option is to screw the Retainer
to the cabinet sides.
2.3.3
Masonry Anchors are supplied with the
accessories to replace the long screws if
attaching the Foot Slide Retainer to
concrete flooring.
Masonry Anchors should not be used if there
is any chance of damaging underfloor
heating.
Check for any protrusions
that may interfere with
the DishDrawer sliding
back into the cavity and
allow for these.
IMPORTANT
IMPORTANT
The Foot Slide Retainer
must be adequately
secured to prevent
movement.
Incorrect
Correct
ü
û
There are two options available for securing the Foot Slide Retainer. Either option is
adequate for securing the DishDrawer. Using both options together is optimum.
STEP 2.2 SECURING THE FOOT SLIDE RETAINER
Page DD_07