Filter
Top Products
12
Installation instructions
11
Attach double sided foam to the back of the
water filter head as shown in Diagram 5. Write
the date to be replaced on the filter (date
installed +6months). Remove double sided foam
backing and attach filter to the desired position
as located in step 10 (refer to previous page).
12
Run the ¼” (6 mm) tubing to back of the
refrigerator ensuring there is enough tubing to
pull out the refrigerator for service.
13
Remove compressor compartment cover by
removing screw at the top of each side of the
cover as shown in Diagram 6. Lift and tilt the
compressor compartment cover to remove as
shown in Diagram 7.
14
Connect tubing into the water (solenoid)
valve located on the right hand side of the
unit (compressor) compartment as shown in
Diagram8. Beware of hotpipes.
15
Pull gently on tubing to ensure it is locked in as
shown in Diagram 9.
16
Place compressor compartment cover back into
position, run the ¼” (6 mm) tubing through
the space provided at the top right hand side
of the compressor compartment cover in an
upward direction and rescrew the compressor
compartment cover.
17
The completed installation should look like
Diagram11 on page 13.
18
Turn isolating faucet on and check that all
connections are dry and free of drips.
19
Coil water line tubing behind the refrigerator.
Pushyour refrigerator into place being careful
notto kink or squash the water line running into
the water (solenoid) valve.
20
Read pages 13 – 14 carefully and then turn
refrigeratoron.
Fig.8 Waterline connection to refrigerator
Diagram 5
Fig.7 Double sided
foam attachment
Diagram 7
Diagram 9
Diagram 8
Diagram 6
US
CA