Filter
Top Products
22
Care and cleaning
Removing and refitting the side racks (and catalytic panels if installed)
Important!
Catalytic panels are not supplied with oven, but can be purchased optionally. Contact your Elba dealer or
visit our local website listed at the end of this document.
To remove a side rack and catalytic panel
1
For easier access to the fixing screws, we recommend removing the oven door first. See
‘Removing and refitting the oven door.’
2
Using a small coin or a flat-head screwdriver, loosen and remove the front and back fixing screws,
as shown.
3
Remove the side rack.
Once you have removed a side rack, the catalytic panel behind it (if fitted) will also be released.
To refit a side rack and catalytic panel
1
If the oven has catalytic panels, align a panel with the fixing screw holes and hold it in place,
making sure that:
the arrow on the panel is pointing up
2
Loosely screw in the the back fixing screw.
3
Position the side rack. Make sure it is the right way up, as shown.
4
Loosely screw in the front fixing screw.
5
Check that both fixing screws are straight, then tighten them.
6
If you removed the door, refit it.
Fig.10 Side rack and catalytic panel in oven cavity
Fixing screw