Filter
Top Products
21
EN
Using your water dispenser
Dispensing
Q
Your water dispenser has been designed for one-handed
operation.
Q
To dispense water push the dispensing pad gently, using
a glass or container.
Q
When you dispense water, a light will appear above the
dispensing area and on the display screen. The water fill
icon
will also appear.
Q
To stop the flow of water, simply pull your glass away
from the dispensing pad.
Please remember that pressing very hard against the
dispensing pad will not make the dispenser operate
faster or produce greater quantities of water.
First use
Q
After installation, on the first use, allow approximately a one minute delay while the dispensing
pad is pushed until water is dispensed. This will allow the tank to fill completely.
Q
After you fill the tank for the first time, dispense and discard approximately 8 – 10 qt (8 – 10 L)
stopping intermittently to flush the tank out.
Important!
To avoid damage to property or personal injury do not put hands, fingers or objects up the
dispenser opening.
Please note that once installation is complete a few drips may appear out of the dispenser over
the next few days as the remaining trapped air is cleared.
Drip Tray
The drip tray is designed to fit into the lip at the bottom
of the water dispenser panel.
To insert the tray always ensure that the rounded sides
are fitted into the dispenser panel first.
The purpose of the tray is to capture any odd drips of
water that may fall after dispensing.
The tray can be easily removed for cleaning (see page 31).
Fig.14 Water dispenser
Fig.15 Drip Tray