Filter
Top Products
20
Start
time
Setting Wall Oven Controls
Clear
/Off
for 3 seconds
Clear
/Off
for 3 seconds
Figure 1
Figure 2
INSTRUCTIONS PRESS DISPLAY
Consumer Defined Controls
Note: The Consumer Defined Control features are adjustments to the control that will not affect cooking results. These
include the Oven Lockout, Silent Control Operation and Temperature Display features.
Setting Oven Lockout Feature
The
Clear
/Off
pad controls the Oven Lockout feature. The Oven Lockout feature automatically locks the oven door and prevents
the Oven from being turned on. It does not disable the clock, Kitchen Timer or the interior oven lights.
Figure 3
Figure 4
Figure 5
INSTRUCTIONS PRESS DISPLAY
To activate the Oven Lockout feature
1. Press and hold
Clear
/Off
for 3 seconds (Figure 1).
2. After 3 seconds "LOC" will appear, a beep will sound and "DOOR
LOCKED" will flash in the display. Once the oven door is locked
the "DOOR LOCKED" indicator will stop flashing and remain on
along with the "LOC".
To reactivate normal oven operation:
1. Press and hold
Clear
/Off
for 3 seconds. A beep will sound. "LOC" will
disepear and "DOOR LOCKED" will flash in the display until the
oven door has completely unlocked (figure 2).
2. The wall oven is again fully operational.
Setting Silent Control Operation
The START TIME
Start
time
and CLEAN
Clean
pads control the Silent Control operation feature. The Silent Control operation
feature allows the oven control to be operated without sounds or beeps whenever necessary. If desired the control can
be programmed for silent operation and later returned to operating with all the normal sounds and beeps.
To change control from normal sound operation to
silent control operation
1. To tell if your range is set for normal or silent operation press and
hold
Start
time
. "0:00" will appear and "DELAY" will flash in the display
(Figure 3). After 7 seconds ":SP" will appear in the display (Figure 4).
2. Press
Clean
to switch between normal sound operation and silent
operation mode. The display will show either ":SP" (Figure 4) or
":--" (Figure 5).
If ":SP" appears (Figure 4), the control will operate with normal
sounds and beeps. If ":- -" appears (Figure 5), the control is in the
silent operation mode.
3. Press
START
to accept the change or press
Clear
/Off
to reject the
change.
START
or
Clear
/Off
Clean