Frymaster L.L.C. 35 Manual

A SERVICE OF

next previous

1-3

After servicing is complete:

5. Return the fryer to its original location, reconnect the unit to the gas supply, and open the gas supply

valve. Be sure to reattach all restraining devices and plug in all electrical cords.

6. Rellthefryerwithoil.

1.3 Diagnostic Procedures

1.3.1 Cleaning the Gas Valve Vent Tube

1. Carefullyunscrewtheventtubefromthegasvalve.

NOTE:Straightentheventtubeforeasyremoval.

2. Pass a piece of binding wire (.052-inch diameter) or equivalent through the tube to remove

obstructions.

3. Removethewireandblowthroughthetubetoensurethatitisclear.

4. Reinstallthetubeandbenditsothattheopeningispointingdown.

1.3.2 Checking the Burner Manifold Gas Pressure

1. EnsurethatthegasvalveknoborbuttonisintheOFF

position.

2. Removethepressuretapplugfromtheendofthemanifold.

3. Connectamanometerorpressuregaugetotheport.

4. PlacethegasvalveinthePILOTpositionandlight.Whentheburnerlightsandcontinuestoburn,

notethegaspressurereadingandcompareittotheaccompanyingtables.

To adjust burner gas pressure:

5. Onnon-CEvalves,removethecapfromtheregulatoradjustmentscrew.

6. Onallunits,increasethesettingonthethermostatuntiltheburnercomeson.

7. Monitorthegaspressurereadingonthemanometerorpressuregauge.

Remove this plug and

connect a manometer or

pressure gauge to the

port.

WARNING

The frypot must be lled

with oil or water during this

procedure.