Filter
Top Products
1-10
1.8.8 Replacing the Frypot
1. Drain the frypot.
2. Remove all accessories (e.g., frypot covers, basket lift arms, etc.) from the fryer.
3. Disconnect the fryer from the gas and electrical power supplies.
4. Remove the screws from the top cap above the
control panel and lift it up and off the fryer(s).
5. If fryer is a G-Model, remove the thermostat
knob.
6. Remove the control panel.
7. Loosen the setscrew on the flexible shaft and
separate it from the thermostat shaft.
8. Remove the two screws holding the flexible
shaft bracket and remove the flexible shaft and
bracket.
9. Remove the control panel frame.
10. Remove the screw from the frypot hold-down
bracket.
Four screws, these two and two on each end, secure the
topcap to the fryer.
The flexible shaft on G-Model fryers must be
disconnected from the thermostat and the shaft and
bracket must be removed.
When the topcap is removed, this screw is
exposed. It must be removed to free the frypot.
11. For fryers with a filter system, remove the square drain tubing from the drain valve.