Filter
Top Products
4-7
DANGER
Do not drain more than one frypot at a time into the built-in filtration unit to avoid
overflow and spillage of hot oil/shortening.
DANGER
NEVER attempt to clear a clogged drain valve from the front of the valve! Hot oil or
shortening will rush out creating the potential for severe burns.
DO NOT hammer on the drain valve with the cleanout rod or other objects. Damage
to the ball inside will result in leaks and will void the Frymaster warranty.
2. Install the Power Shower. NOTE:
Verify that the Power Shower O-ring
and gasket are present and in good
condition and that the clean-out screws
are installed at each corner.
Install the Power
Shower in the frypot
to be filtered.
Snap the Power Shower into position.
DANGER
DO NOT operate the filter without the Power Shower in place. Hot oil will spray out of
the fryer and cause injury.
3. After the cooking oil/shortening has
drained from the frypot, rotate the Oil
Return handle left to the RETURN
position to start the pump and begin the
filtering process. There may be a slight
delay before the pump activates. On
fryers equipped with an optional rear-
discharge system (See Section 4.6),
rotating the handle to the right will
discharge the oil.
Rotate the handle to the left to return oil to the frypot.
Rotate to the right on fryers with optional rear-
discharge to dispose of the oil.