Filter
Top Products
6-8
6.6 Replacing the Controller or Controller Wiring Harness
1. Disconnect the fryer from the electrical
supply.
2. Remove the two screws in the upper
corners of the control panel and swing the
panel open from the top, allowing it to
rest on its hinge tabs.
3. Disconnect the wiring harness from the
back of the controller and, if replacing the
harness, disconnect it from the interface
board (arrows).
4. If replacing the controller, disconnect the
ground wire and the 15-pin connector
(arrows), and then remove the controller
by lifting it from the hinge slots in the
control panel frame.
5. Reverse the procedure to install a new
controller or wiring harness.
If replacing harness, disconnect the harness from the
controller and interface board (arrows).
If replacing controller, disconnect the ground wire and
the 15-pin connector (arrows).