Filter
Top Products
1-19
Filtration Malfunction
The majority of ltration malfunctions arise from operator error. One of the most common errors is
placing the lter paper on the bottom of the lter pan rather than over the lter screen.
Inspect the lter paper to ensure that it is correctly sized and placed. Incorrectly sized or installed lter
paper will allow particles and sediment to pass through the lter pan and into the pump. When sediment
enters the pump, the gears can bind and cause the motor to overheat. If the motor overheats, the thermal
overload will trip to protect the motor from further damage. Reset the motor by pressing the red reset
button the end of the motor nearest the operator. Sediment cannot enter the pump when the correct
lter paper is used properly.
While you are checking the lter paper, verify that the O-rings on the lter pan and connectors are
present and in good condition. Missing or worn O-rings will allow the pump to suck air and decrease its
efciency.
A pump seized by debris or hard shortening can usually be freed by manually moving the gears with a
screwdriver or other tool.
1. Disconnect power to the lter system.
2. Remove the input plumbing from the pump.
3. Use a screwdriver to manually turn the gears.
• Turn the pump gears backward to release a hard particle
and remove it.
• Turn the pump gears forward to push softer objects and
solid shortening through the pump and allow the gears to
move freely.
Incorrectly sized or installed paper will also allow food particles and sediment to pass through and clog
the suction tube on the bottom of the lter carriage. Particles large enough to block the suction tube may
indicate that the crumb tray is not being used during ltering.
Pan blockage can also occur if shortening remains in the pan and solidies. The heater strip on the
suction tube prevents solidication of residual shortening left in the tube. It will not melt or prevent
solidication of shortening in the pan. Remove blockages by forcing the item out with an auger or drain
snake. Compressed air or other pressurized gases should not be used to force out the blockage.
The Power Shower may need service for clogged openings, shortening solidied in the tubes, missing
clean-out plugs, and missing or worn O-rings. To correct these problems, clean the unit and replace
missing or worn plugs and O-rings.
Up for reverse
Sediment
Particle
Oil Flow
Down for forward
Sediment
Particle
Removing debris or shortening from
a seized pump.