Frymaster D20 Series Fryer User Manual


 
DECATHLON SERIES GAS FRYERS (CE)
CHAPTER 5: THERMATRON OPERATION
5-1
5.1 Operating Fryers with Thermatron Controllers
Many Decathlon fryers use a solid-state
temperature controller, or Thermatron
®
controller
instead of a computer or basic thermostat. A
Thermatron
system incorporates a temperature-
control circuit board, a potentiometer, and a
temperature probe. This system is more accurate
and more reliable than a standard thermostat, and
less expensive than a computer controller.
Various switch options are available on
Decathlon frying systems. Two typical
configurations on current production systems are
illustrated below (switch locations will vary from
model to model).
Configuration #1
Thermatron Temperature Controller
POWER
BOIL OUT
FF
N
F
BOIL OUT
F
O
F
O
N
F
F
O
F
POWER
O
O
O
MK
N
O
N
MAIN POWER
U
P
T
O
ON OFF ON
A
C
B
T
Fryer Power Switch: controls power to
each individual fryer, both in Thermatron or
back-up mode.
Boil-Out Switch: operates only in "Thermatron" mode. When
"ON", this switch bypasses the Thermatron melt-cycle and
allows the water temperature to reach 196°F.
Main Power Switch (optional): connects/disconnects primary
power; double-lighted with center position "OFF". This switch
controls two Thermatron controllers /Compu-Fry computers and/or
two back-up thermostats (optional).
High-Limit Reset Switch: located under
each individual control panel. This
switch must be manually reset if fryer
exceeds high-limit setpoint.
Filter Reset Switch [7 Amp (115VAC)
or 5 Amp (230VAC) Circuit Breaker]: this
switch is inline between the filter pump
and incoming line voltage. Ensure
power is "OFF" before resetting or
replacing.
MK
T
U
MAIN POWER
P
T
A
C
ON OFF ON
B
OR
C
O
M
P
U
T
E
R
OR
C
O
M
P
U
T
E
R