Filter
Top Products
ENGLISH
Description of parts:
FIG. 01
1 Main switch
2 Coffee dispensing button
3 Coffee dispensing button
4 Hot water button/pump
5 Steam button
6 Doses programming button/manual
operation
7 Steam/hot water knob
8 Turbo frother steam nozzle (removeable)
9 Filterholder
10 1 cup filter (or coffee pod)
11 2 cup filter
12 Drip tray
13 Perfect crema device
14 Brewing head
15 Filterholder gasket
16 Shower disc holder
17 Shower disc
18 Tamper
19 Power cable and plug
20 Measuring spoon
21 Delivery spout
22 Tank cover
23 Removable decompression duct
24 Milk frother (removeable)
25 Drip plate
26 Removable water tank
Instructions for the power supply cord
A A short power-supply cord is provided to
reduce risks of getting tangled up or tripping
over a longer cord.
B Longer extension cords are available and
may be used if care is exercised in their use.
C If a long extension cord is used:
1 the marked electrical rating of the extension
cord should be at least as great as the
electrical rating of the appliance.
2 if the appliance is of the grounded type, the
extension cord should be a grounding type
3 the cable does not hang from the table to
avoid the risk of getting caught up in it.
Preparation:
1. Remove the water tank cover (22) and fill
with cold water to the MAX line indicated on
tank (26). See FIG. 2.
The water tank can also be removed after
disconnecting the decompression duct (23) and
removing the drip plate (25).
IMPORTANT: Once the tank has been
reinserted, ensure that the silicon pipes are
inside the actual tank and not tangled or
blocked.
Re-install the decompression duct (23).
2. Insert plug (19) into a suitable wall outlet
(see point 1 under Caution).
3 Press main switch (1). The starting pilot light
will light up and the symbols of the different
buttons will alternatively light up.
Make sure that buttons 2 - 3 - 4 and 5 are off
(not pressed)
Starting up
This procedure fills the water boiler with fresh
water.
This should be done whenever the machine is
switched on.
This machine, featuring a pump to brew coffee,
is equipped with a self-priming system.
3Place an empty cup under steam rod (8), turn
steam knob (7) and press (keeping pressed)
hot water button (4).
You will hear the noise of the enabled pump
and after a few seconds water will come down
from steam rod (8).
When the cup is filled release hot water button
(4) and close steam knob (7).
The Gaggia machine is now ready to be used.
Another feature of the machine is the no-drip
system, eliminating most of dripping from
brewing head (14).
9