Filter
Top Products
LIGHT BULB REPLACEMENT
Cooktop Light./Night Light
To replace
combination
cooktop/night
light, first
disconnect
power at main
fuse or circuit
\
breaker panel or pull plug.
REMOVE SCREW
Remove screw on right side of light compartment
cover and lower cover until it stops.
Be sure bulbs to
be replaced are
cool before
removing. Break
the adhesive seal by
gently unscrewing
the bulbs. Replace
with 40-watt
incandescent bulbs (WB02X4253) ‘available from
your GE supplier. High intensity 40-watt bulbs
(40S 1 IN/1), which are available in supermarkets and
hardware stores, may also be used for replacements.
Raise light compartment cover and replace screw.
Connect electrical power to microwave oven.
Oven Light
r
To replace your oven light, first
disconnect
Dower
at main fuse
or circuit
b;eaker panel or pull
plug.
Remove the top grill by
taking out the 2 screws that hold
it
in place.
Next,
remove the single screw
located above door near center
of oven that secures light housing.
Replace burned-out bulb with
a 30-watt incandescent bulb
(WB02X4235), available from
your GE supplier.
Clean off the grease and dust on
hood surfaces often. Use a solution
of warm water and detergent.
About 1 tablespoon of ammonia
may be added to the water. Take
care not to touch the filters and
enamel surfaces with this solution;
ammonia will darken metal.
30