GE 24 CustomStyle Refrigerator User Manual


 
12
Customer Service Troubleshooting Tips
Operating Instructions
Safety InstructionsInstallation InstructionsCustomer Service Troubleshooting Tips Installation Instructions Safety Instructions
Operating Instructions
Customer Service Troubleshooting Tips Installation Instructions Safety Instructions
Operating Instructions
About storage drawer removal.
Not all features are on all models.
About the refrigerator doors
Drawer Removal
Drawers can easily be removed by tilting up
slightly and pulling past the
stop
location.
Remove the door bins from the fresh food door
before removing the drawer.
To remove the shelf above the top drawer,
first remove the top drawer and any food on
the shelf. Then tilt the shelf up at the front
and lift it up and out of the tracks.
To replace the shelf, raise the shelf front
slightly and place the top hooks in the
lowest large track slots. Then lower the
front of the shelf until it is level.
To remove the drawers when the fresh food
compartment door cannot be opened fully
you need to roll the refrigerator forward
until the door can be fully opened. In some
cases this will require moving the
refrigerator to the left as you roll it out.
When replacing the drawers, make
sure you slide them through both
drawer guides on the right side.
Drawer
Guides
Refrigerator Doors
The refrigerator doors may feel different
than the ones you are used to. The special
door opening/closing feature makes sure
the doors close all the way and are securely
sealed.
When opening and closing the door you
will notice a
stop
position. If the door is
opened past this
stop
point, the door will
remain open to allow you to load and
unload food more easily. When the door is
only partially open it will automatically
close.
The resistance you feel at the
stop
position will be reduced as the door
is loaded with food.
When the door is only partially open
it will automatically close.
Beyond this stop the door will
stay open.