GE 24 CustomStyle Refrigerator User Manual


 
Customer ServiceTroubleshooting Tips
Operating InstructionsSafety Instructions
Installation Instructions
7
When Your Refrigerator Is First Plugged In
How the Monitor and Diagnostic System Works
All panel lights come on for five seconds,
a beep sounds, and lights go off except as
follows:
PF
flashes in the display. Touch
SYSTEM
CHECK-RESET
to erase it.
NORMAL
glows.
WARM TEMP
glows until the refrigerator
cools down. It goes off when proper food-
keeping temperature is reached.
Door alarm beeper is activated and
DOOR
ALARM
glows.
CRUSHED ICE
glows.
DOOR OPEN
flashes if either door is open,
goes out when doors are shut.
Night light in ice and water dispenser
is off.
How to Set the Door Alarm
To set the alarm press
DOOR ALARM
until it
glows.
The control beeps if either door is open for
more than 30 seconds.
The light goes out and the beeping stops
when you close the door.
DOOR ALARM
ON/OFF
Why the WARM TEMP Light Glows
At first, it’s probably because your newly-
installed refrigerator hasn’t completely
cooled down yet. Wait a few hours for it to
cool, and then the light will go out.
From then on,
WARM TEMP
will glow
whenever temperatures inside get too high
for proper food storage. If this happens,
open the doors only when absolutely
necessary, and close them as quickly as
possible.
As soon as inside temperatures return to
normal, the light goes out.
If
WARM TEMP
reappears and stays on for
longer than 4 hours, call for service.
WARM
TEMP
The diagnostic code flashes and the control
beeps when something starts to go wrong.
If more than one coded function requires
attention at the same time, the one with the
highest priority will be displayed first.
Pressing
SYSTEM CHECK-RESET
will erase
two codes immediately—
PF
and
CI.
The
dE
and
FF
codes can only be erased by pressing
SYSTEM CHECK-RESET
after the condition
that caused the code to flash has been
corrected.
SYSTEM CHECK-RESET
will also evaluate
all other coded functions. If
NORMAL
is
lit during the displaying of a code, that
function is operating properly.
SYSTEM
CHECK
RESET