GE 24 CustomStyle Refrigerator User Manual


 
Customer ServiceTroubleshooting Tips
Operating InstructionsSafety Instructions
Installation Instructions
Preparing to install the refrigerator.
Read these instructions completely and carefully.
Water Supply to the Icemaker
You will need to connect the icemaker to a cold
water line.
A water supply kit (containing copper tubing,
shutoff valve, fittings and instructions) is available
at extra cost from your dealer or from Parts and
Accessories, 800-626-2002.
Refrigerator Location
Install it on a floor strong enough to support it
fully loaded.
Clearances
Allow the following clearances for ease of
installation, proper air circulation and plumbing
and electrical connections.
24
Model 28
Model 30
Model
Sides 1/8 (3 mm) 1/8 (3 mm) 1/8 (3 mm)
Top 1 (25 mm) 1/8 (3 mm) 1/8 (3 mm)
Back
1/2 (13 mm) 1/2 (13 mm) 1/2 (13 mm)
If built-in, allow 7/8
(22 mm) for hinge covers.
If the refrigerator is against a wall
on either side, allow 3/4 (19 mm)
on each side for a 90° door opening.
Leveling Rollers
The rollers have 2 purposes:
The rollers can be adjusted so the refrigerator is
firmly positioned on the floor and does not rock
back and forth.
Rollers allow you to move the refrigerator away
from the wall for cleaning.
To adjust the rollers,
remove the base grille by pulling
it out at the bottom.
Turn the two front roller adjusting screws
clockwise
to raise
the refrigerator,
counterclockwise to lower
it. Use a 3/8 socket wrench, adjustable wrench or
pliers.
Built-In Style models also have rear adjustable
rollers so you can align the refrigerator with your
kitchen cabinets. Use a 5/16 socket wrench to turn
the screws for the rear rollers—
clockwise to raise it,
counterclockwise to lower it.
2
1
19
Front Roller
Adjusting Screw
Rear Roller Adjusting Screw
(on Built-In Style models only).
Use this screw if the refrigerator
has one.
Rear Roller Adjusting Screw
(on Built-In Style models only).
Use this screw if the refrigerator
does not have the screw pictured
to the left.
Front Roller
Adjusting Screw
90°