Filter
Top Products
Installation Instructions.
Installing the Tubing
1. Measure 3/4″ from the end of each remaining piece of tubing (faucet end and inlet end) and mark with a pencil (Fig. 10). (Check
for roundness, smoothness, cuts, nicks, flat spots and sharp edges.)
2. NOTE: Water flow is from left to right. Water inlet is on the left side and water outlet is on the right side. Failure to follow will result in water
leaks when filter canisters are removed.
3 Push the tubing firmly into each fitting on the manifold until the line is flush with the fitting collar. (If the tubing is removed, re-cut
the end, measure, mark and re-insert). Tubing must be fully inserted to avoid leaks (Fig. 11). (To remove tubing, depress and hold white
collet; pull tubing out to remove.)
4 Pull out slightly on tubing to ensure a good seal.
3/4″
(19 mm)
Fig. 10
INCORRECT
12
Inlet from supply valve
Outlet
to faucet
3
4
"
Engagement
3/4″(3/8″ tubing)
White Collet
(DO NOT REMOVE)
Insertion line
Insert tubing
Fig. 11