Filter
Top Products
CONNECT THE WATER LINE
• Squeeze the ends of the hose clamp (3) or (6) from
the kit with pliers and slide the clamp over the
water tube inlet. (Use the black clamp (3) with
the black fill tube inlet, use the other clamp (6)
with the other fill tube inlet.)
• While still squeezing the clamp, insert the
plastic water line into the inlet as far as it will
go (approximately 1″ [25 mm]).
• Then slide the clamp downward to capture the
plastic water line in place.
• Make sure the fill tube is aimed down.
Installation Instructions
INSTALL WATER LINE CLAMP
• Attach the metal water line clamp (strain relief)
(8) to the refrigerator. Drive the screw (7) from the
kit through the clamp (8) at the indent into the
back of the cabinet.
• The metal clamp is for the house water line (see
the Water Line Installation Instructions). It is not
to be used for the tubing from the water valve up
to the icemaker.
3
4
Water tube
inlet
ATTACH THE PLASTIC WATER LINE
Fasten the plastic water line to the back of the
cabinet with adhesive-backed fasteners (5),
spacing the fasteners as shown to take up the
slack in the line.
5
WATER VALVE INSTALLED
Refer to the Water Line Installation Instructions for
connection to the home water supply. After water
line installation is completed, set the icemaker
power switch to ON.
The icemaking cycle will not begin until the
icemaker and freezer compartment reach
operating temperature, then icemaking will
begin automatically.
6
7
8
3
6
or
21
Adhesive-backed fasteners
for plastic water line
5