Filter
Top Products
Installation Instructions
WATER VALVE INSTALLED
Refer to the Water Line Installation Instructions for
connection to the home water supply. After water
line installation is completed, set the icemaker
power switch to ON.
The icemaking cycle will not begin until the
icemaker and freezer compartment reach
operating temperature, then icemaking will
begin automatically.
5
53
ROUTE AND ATTACH THE PLASTIC
WATER LINE
• Fasten the plastic water line to the back of the
cabinet with adhesive-backed fasteners (5),
spacing the fasteners as shown to take up slack
in the line. (It may be necessary to remove the
screw from the top right condenser mounting
clip for better access to the water tube inlet.)
4
Adhesive-backed fasteners
for plastic water line
3
CONNECT THE WATER LINE
• It may be necessary to remove the screw from
the top right condenser mounting clip for better
access to the water tube inlet.
• Make sure there is enough plastic water line to
extend from the water valve to well into the
water tube inlet (15). Cut off any excess tubing.
• Squeeze the ends of the hose clamp (3) from the
kit with pliers and slide the clamp over the water
tube inlet.
• While still squeezing the clamp, insert the plastic
water line into the inlet as far as it will go
(approximately 1″ [25 mm]).
• Then slide the clamp downward to capture the
plastic water line in place.
• Make sure the fill tube is aimed down.
• If the condenser mounting screw was removed,
secure the condenser to the refrigerator by
replacing the mounting clip and screw.
• Do not overtighten the screw.
3
Water tube
inlet