Filter
Top Products
34
2
Installation Instructions
ICEMAKER INSTALLATION INSTRUCTIONS L
Are these the right instructions for your model? Follow the Installation Instructions indicated by
the label on the back of the refrigerator— or
TSRQPNMLKJHGFC
BEFORE YOU BEGIN
Read each step thoroughly before proceeding.
•
CAUTION – Unplug the
Refrigerator. To eliminate the danger
of electric shock during installation,
you must unplug the refrigerator
from its electrical outlet.
Flat blade and Phillips
screwdrivers
Pliers
TOOLS YOU WILL NEED
Sharp knife
SET POWER SWITCH TO OFF
Set the icemaker power switch to OFF. Leave
the power switch in the OFF position until the
refrigerator is connected to the water supply to
prevent premature operation.
4
1
REMOVE ICE CUBE TRAY SHELF
• Remove the two screws securing the ice cube tray
to the side wall of the freezer. Remove the tray.
• Replace the screws but do not screw them all the
way in. The screw heads should extend about
1/2″ (13 mm) from the side wall of the freezer.
1/4″ Nutdriver or adjustable wrench
Remove
plug
INSTALL FILL TUBE EXTENSION
• Cut the fill tube extension (10)
to the length (refer to the
template on page 67) with
a sharp knife or a single-edge
razor blade and slide it onto
the fill tube against the stop.
L
L
3
PREPARE FOR INSTALLATION
• Remove and discard the large white plug from
the rear freezer wall.
• Remove the outlet cover with a flat-blade
screwdriver.
L
10
Power
Switch
Hole for
wire tie
(Appearance may vary)