Filter
Top Products
38
PREPARE FOR INSTALLATION
Inside the freezer, loosen the two mounting screws
(B) but do not screw them all the way out. If your
model does not have the screws already in the
freezer wall, look for two plug buttons. Remove the
plug buttons and insert the two Phillips head screws
(14). The screws should extend approximately
1/2″ (13mm) out from the freezer wall.
3
Installation Instructions
ICEMAKER INSTALLATION INSTRUCTIONS M
Are these the right instructions for your model? Follow the Installation Instructions indicated by
the label on the back of the refrigerator— or
TSRQPNMLKJHGFC
BEFORE YOU BEGIN
Read each step thoroughly before proceeding.
•
CAUTION – Unplug the
Refrigerator. To eliminate the danger
of electric shock during installation,
you must unplug the refrigerator
from its electrical outlet.
Flat blade and Phillips
screwdrivers
Pliers
TOOLS YOU WILL NEED
Sharp knife
REMOVE THE OUTLET COVER
• Remove the outlet cover
with a flat-blade screwdriver.
2
B
SET POWER SWITCH TO OFF
Set the icemaker power switch to OFF. Leave
the power switch in the OFF position until the
refrigerator is connected to the water supply to
prevent premature operation.
5
INSTALL FILL TUBE
• If the refrigerator already
has a water tube inlet on
the back of the refrigerator,
go to Step 2.
• Cut the fill tube (16) to the
length (refer to the
template on page 66)
with a sharp knife or
a single-edge razor blade.
• Slide the fill tube (16) onto
the water tube inlet (15).
• Go to the back of the refrigerator. Find the small label
in the upper right hand corner and peel it off. On the
tube side of the water tube inlet (15) there is an
adhesive backing. Remove the adhesive backing and
slide the tube into the hole near the top at the back
of the refrigerator. Firmly press on the inlet to secure
it to the refrigerator.
M
M
1
15
16
INSTALL FILL TUBE EXTENSION
• Remove and discard the white plug from the
upper left corner of the freezer wall.
• Cut the fill tube extension (10) to the length
(refer to the template on page 67) with a sharp
knife or a single-edge razor blade and slide it onto
the fill tube against the stop.
M
M
4
Remove
plug
M
10
Power
Switch
Hole for
wire tie
(Appearance may vary)