GE JBP26GP Range User Manual


 
Follow These Steps after
Self-Cleaning
After cleaning is complete, the
door will stay locked until the oven
cools down. This takes about
30
minutes.
Step 1:
When oven has cooled, slide the
latch
handle to the left as
far
as it
will
go
and open the door. If the
door will not open move the latch
handle
back
to the right, wait an
additional 15 minutes and then try
again.
D
O
not
force
the latch handle.
Step
2:
Turn OVEN SET knob to OFF.
Step
3:
. Turn OVEN TEMP knob to
WARM.
NOTE: To start and stop cleaning
at
a time later than shown on
clock, push in and turn DELAY
START
di:il
to time you wish
cleaning to start. Then set STOP
TIME dial for three hours later
than the Start Time. Oven will
automatically turn on and
off at the
set times.
Questions and Answers
Q. Why won’t my oven clean
immediately even though I set all
the time and clean knobs correctly?
A. Check to be sure your DELAY
START dial is set to the same time
as the range clock. Also check to
be sure latch handle is moved to
the right.
Q. If my oven clock is not working,
can I still self-clean my oven?
A. No. Your Automatic Oven
Timer uses the range clock to help
start and stop the self-cleaning
cycle.
Q. Can I use commercial oven
cleaners on any part of my
self-
cleaning oven?
A. No
cleaners or coatings should
be used around any part of this oven.
If
you do use them and do not wipe
the oven absolutely clean afterward.
The residue can scar the oven surface
and damage metal parts the next time
the oven is automatically cleaned.
Q. Can I clean the Woven
Gasket around the oven door?
A. No, this gasket is essential for a
good oven seal, and care must be
taken not to rub, damage or move
this gasket.
Q. After having just used the
oven, I could not move the latch
handle. Why?
A.
After several continuous
high-
temperature bakings or
broilings,
the door cannot be latched. If this
happens, let the oven cool by
opening the oven door. After the
oven has cooled, you will be able to
latch the oven door for self-cleaning.
Q. What should I do if excessive
smoking occurs during cleaning?
A.
This is caused by excessive soil,
and you should switch the OVEN
SET knob to OFF. Open windows to
rid room of smoke. Allow the oven
to cool for at least one hour before
opening the door. Wipe up the excess
soil and reset the clean cycle.
Q. Is the “crackling” sound
I
hear during cleaning normal?
A. Yes. This is the metal heating
and cooling during both the
cooking and cleaning functions.
Q. Should there be any odor
during the cleaning?
A. Yes,
there may be a slight odor
during the first
few
cleanings.
Failure to wipe
oLlt
excessive soi]
might also cause an odor when
cleaning.
Q. What causes the hair-like
lines on the enameled surface of
my oven?
A. This is a normal condition
resulting from heating and cooling
during cleaning. They do not affect
how your oven performs.
Q. Why do
I
have ash left in
my
.
oven after cleaning?
A. Some types of soil will leave
a deposit which is ash, It can be
removed with a damp sponge or
cloth.
Q. My oven shelves do not slide
easily. What is the matter?
A.
After many cleanings, oven
shelves may become so clean
they do not slide easily. To make
shelves slide more easily
after each
self-cleaning cycle, dampen fingers
with a small amount of cooking oil
and rub lightly over sides of shelf
where they contact shelf supports.
Q. My oven shelves have become
gray after the self-clean cycle. Is
this normal?
A. Yes. After the self-clean cycle,
the shelves may lose some luster
and discolor to a deep gray.
Q. Can
I
cook food on the cooktop
while the oven is self-cleaning?
A. Yes.
While the oven is
self-cleaning, you can use the
cooktop just as you normally do.
21