Filter
Top Products
STEP
2
PRE*RE
FOR ELECTRIUL CONNECTION
Use only a 3-conductor, or if required a
4-
conductor range cord set as noted below.
These cord sets are provided with ring
type terminals.
The electrical rating of the cord must be
125/250 volts minimum, 40 amperes.
NOTE: Only a 4-conductor cord is to be used
when the appliance is installed in a mobile
home or where local codes do not permit
grounding through the neutral.
STEP 3
1.
hcate
connector block at the bottom rear
of range and remove rear wiring cover.
2. Directly below the connector block is a
hole with a knockout ring for accommodating
conduit fittings. Brackets provided are used
t(
support the flexible cord strain relief, which
must be securely attached to the cord set.
I II
STEP
4
1-
3WIRE
SYSTEM
Power Cord Installation-Insert screws
through power cord terminals so that the
screws pass through connector block terminals
and engage nuts. Tighten screws securely.
SCREW
+
9
POWER CORD
RING TERMINAL
>%
&
L
+&
+
POWER
CORD
:~:::CTOR
TERMINAL
*
MOVABLE
NUT
I
Cable Direct Insolation-Clamp bare wires
between the connector
block terminals and
movable nuts with screws tightened securely.
-
.
--
FLEXIBLE
MOVABLE
NUT
~
@-
i
1.
Copper Wiring
Connect the neutral or grounded wire of the
supply circuit to the neutral terminal of the
connector block, located in the center. The
power leads must be connected to the outside
@rass
colored) terminals.
UTRAL
RMINAL
GROUNDING STRAP
(GROUNDED TO RANGE)
—
28