Filter
Top Products
OVEN CONTROL, CLOCK
Am
T~ER
Clock
To Set the Clock
The clock must be set for the automatic oven timing
functions to work properly. The time of day cannot
be changed during a Timed Baking or Self-Cleaning
cycle.
n
1. Press the CLOCK pad.
CLOCK
2.
Press the INCREASE or DECREASE pad to set the
time of day.
n
3. Press the CLOCK pad to start.
CLOCK
Timer
To Set the Timer
The timer is a minute timer;
it does not control oven operations.
The maximum setting on the timer
n
1.
Press the TIMER pad.
TIMER
is 9 hours and 55
mi~utes.
n
2. Press the INCREASE
A
or DECREASE pad
~
to set the amount of
time on the timer.
The timer will start automatically
within a few seconds of releasing
the pad. The timer, as you are
setting it, will display seconds until
1 minute is reached. Then it will
display minutes and seconds until
60 minutes is reached.
After 60 minutes, it will display
hours
(“HR”
now appears in
display) and minutes until the
maximum time of 9 hours and
55 minutes is reached.
To Reset the Timer
To Cancel the Timer
If “TIMER” is displayed, press the INCREASE or
Press and hold the TIMER pad until the word
DECREASE pad until desired time is reached.
“TIMER” disappears from the display.
If “TIMER” is not displayed, press the TIMER pad
first, then follow the instructions above to set the timer.
End of Cycle Tone
Display Messages
The end of cycle tone is a series of three beeps
If
“door”
appears in the display, the door is open.
followed by one beep every six seconds. If you would
Close the door. If “LOCK” appears in the display, the
like to remove the signal that beeps every six seconds,
oven door is in the locked position. BAKE, BROIL
press and hold the
CLEAWOFF pad for 10 seconds.
and COOK TIME cannot be set if the door is in the
To return the signal that beeps every six seconds,
locked position.
press and hold the CLEAWOFF pad for 10 seconds.
Power Outage
After a power outage, when power is restored, the
All other functions that were in operation when the
display will flash and time shown will no longer be
power went out will have to be programmed again.
correct-for example, after a 5-minute power
interruption the clock will be 5 minutes slow.