Filter
Top Products
OVEN CONTROL CLOCK
Am
TMER
Clock
To Set the Clock
The clock must be set for the
automat
ic
oven timing functions to
work properly. The time
of day
ctinnot
be changed during
u
Timed
Bake or CLEAN cycle.
Step
2: Press the
INCREASE or
DECREASE pad
to
set the time of day.
Step 3: Press the CLOCK pad
to start.
Timer
To Set the Timer
The timer is a minute timer only.
The timer does
not
control oven
operations. The
mtiximum
setting
on the timer is
9
hours
tind
55 minutes.
1
Step 1:
Press the
TIMER pad.
TIMER
Step 2: Press the INCREASE or
DECREASE pad to set the amount
of time on timer.
The timer will
sttirt
automtitically
within
a
few seconds of releasing
the pad.
The timer, as you are setting
it, wil I display seconds until
60 seconds is reached.
Then it will display minutes
and seconds until 60 minutes
is reached.
After 60 minutes, it will display
hours (“HR” now appears in
display) and minutes until the
maximum time of
9
hours and
55 minutes is reached.
To Reset the Timer
To Cancel the Timer
Power Outage?
If “TIMER” is showing, press the
Press the TIMER
p~d
until the
After
a
power outage, when power
INCREASE or DECREASE
pad
word “TINIER” quits
tlashing
on
is restored, the display will
tlash
until desired time is reached.
the
displtiy
(Jbout
4 seconds).
and time shown will no longer be
If
“TIMER” is
nt)t
showing, press
correct-for example, after
a
the TIMER
pud
first, then follow
5-minute power interruption the
instructions
tibovc
to set the timer.
clock will be 5 minutes slow.
The displav flashes until the clock
.
is reset.
-
All other functions that
were in operation when the power
went out will have to be
programmed again.
Display Messages
End of Cycle Tone
If “DOOr” appears on the display,
the door is open.
The end of cycle tone is a series of three beeps
Close the door. [f .’LOCK” appears on the display. the
followed by one beep every six seconds. If
YOU
WOUl~
oven door is in the locked position. BAKE, BROIL
like to remove the signal that beeps every six seconds,
and COOK TIME
c~nnol
be
set if the door is in the
press and hold the CLEAR/OFF pad for 10 seconds.
locked position.
To return the signal that beeps every six seconds,
press
and
hold the CLEAR/OFF pad for I () seconds.
9