GE JMP29GR Range User Manual


 
Clock
To Set the Clock
The clock must be set for the
automatic oven timing functions to
work properly. The time of day
cannot be changed during
a TIME
BAKE or CLEAN cycle.
n
Step 1: Press the
CLOCK pad.
CLOCK
J
A
Step 3: Press the CLOCK pad
Step 2: Press the
INCREASE or
DECREASE pad to
set the time of day.
to start,
Timer
To Set The Timer
The timer is an alarm or minute
timer only. The timer does not
control oven operations. The
maximum setting on the timer is
9 hours and 55 minutes.
TIMER
Step 1: Press the
TIMER pad.
Step 2: Press the INCREASE or
DECREASE pad to set the amount
of time on timer.
The timer will start automatically
within a few seconds of releasing
the pad.
The timer, as you are setting it,
will display seconds until 60
seconds is reached.
Then it will display minutes
and seconds until 60 minutes
is reached.
After 60 minutes, it will display
hours (“HR” now appears in
display) and minutes until the
maximum time of 9 hours and
55 minutes is reached.
To Reset Timer
To Cancel Timer
Power Outage?
It “TIMER” is showing,
press the INCREASE or
DECREASE pad until desired
time is reached.
If “TIMER” is not showing,
press the TIMER pad first then
follow instructions above to set
the timer.
Press the TIMER pad until the
After a power outage, when power
word “TIMER” quits flashing on
is restored, the display
will
flash
the display (about 4 seconds).
and time shown will no longer be
correct-for example, after a
5-minute power interruption the
clock will be 5 minutes slow.
The display flashes until the clock
is reset. All other functions that
were in operation when the power
went out will have to be
programmed again.
End of Cycle Tones
Display Messages
The end of cycle tone is three short beeps followed
If “door” appears on the display, the door is open.
by one beep that repeats every six seconds until you
Close the door. If “LOCK” appears on the display, the
press any operation. If you would like to eliminate the
oven door is in the locked position. BAKE, BROIL
repeating beeps, press and hold the
CLEAIUOFF pad
and COOK TIME cannot be set if the door is in the
for ten seconds.
locked position.
To return the timer tone to the repeating beeps, press
and hold the CLEAR/OFF pad for 10 seconds.
9